Loading media Z4M with Peel and Present

The first part shows the loading (note the sharp angle that the material must be on to go to the rewinder). After the material is loaded the printer does an auto calibration where it outputs blank labels. After this 2 test labels were sent from Zebra Label Designer. The only option selected in the printer settings (Advanced Tab) is "Peel Off". You will see the printer advances one label at a time and waits for the label to be removed.

 

Go here to see the video.

 

 


 

Tutorial Information

 

If you need further help, would like to be advised of future tutorials, or have a tutorial suggestion just email us.

 

These tutorials are copyright of Pos Shop Pty Ltd. You are free to distribute this or publish this to others provided it is distributed without changes, complete and acknowledges All About Labels as the author. Whilst every care has been taken to ensure the accuracy of the information provided, no warranty whether implied or stated is given as to the information's accuracy or suitability. As we are not aware of your exact situation the content is used at your own risk entirely.